Truck Canopy or Trailer Slimline II Rack Kit / 1165mm(W) X 1156mm(L) - by Front Runner

$ 715.00
FREE SHIPPING
TO THE LOWER 48 STATES*
In stock - available for immediate delivery
Product Code
KRCA004T

This Rack Kit is for truck canopies/camper shells/caps and trailers that have roof top sizes no larger than approximately 1165mm/45.9" (W) x 1156mm/45.5" (L). The Slimline II Tray mounts to four (4) supplied Feet that slide in to the supplied Track. The 1150mm/45.3" long pair of tracks can be easily mounted to your canopy/shell or trailer.

See the Track installation instructions in the INSTALL tab for further details.

  • Proven gear and advice
    You can trust
  • 30 day money back
    Guarantee
  • Built off-road
    Tough

All Front Runner Rack Kits contain installation instructions as well as all the components needed to mount the Slimline II Tray to your vehicle.

All Front Runner Racks are backed by a Limited Lifetime Warranty*

KRCA004T - Truck Canopy or Trailer Slimline II Rack Kit / 1165mm(W) X 1156mm(L) - by Front Runner

Consisting of:

2 x FASS012 - Foot Set / 40mm-50mm - by Front Runner
1 x RRSTA06 - Slimline II Tray - 1165mm(W) X 1156mm(L) - by Front Runner
1 x TRCA003 - Canopy Tracks / 1150mm(L) - by Front Runner

 Material used:

Black epoxy powder-coated T6 aluminium
3CR12 Stainless Steel

Approximate Installed Weight 20kg (43lbs)

The t-slots on the tops and bottoms of the rack tray slats and edge profiles accommodate standard 8mm bolts.

To determine the approximate height from your vehicle’s roof to the top of your Slimline II Roof Rack, add the height of the Slimline II Tray (50mm/ 2") to the height of the Foot, Grab-on Foot or Strap-On Foot listed above.

If your Slimline II Roof Rack kit uses Legs, add the height of the Slimline II Tray (50mm/ 2") to the height of the Legs to determine the height of the rack from your vehicle’s rain gutters.

If your Slimline II Roof Rack kit uses Foot Rails, add the height of the Slimline II Tray (50mm/ 2") to the height of the Foot Rails to determine the height of the rack from the crown (highest point) of the vehicles roof.

 Shipping Dimensions:

Width 450mm (18")
Length 1615mm (64")
Height 140mm (6")

 
Shipping Weight:

Weight 22.9kg (50.4lbs)

 
Write Your Own Review
You're reviewing:Truck Canopy or Trailer Slimline II Rack Kit / 1165mm(W) X 1156mm(L) - by Front Runner
Your Rating
Product Questions
The top of my shell rounds off at the edges leaving the flat surface area only about 35" wide. Can this rack be mounted on tracks 35" apart ?
Question by: wayne smith
Yes. You will be able to mount the Canopy Rack (KRCA004T) to your shell with the tracks 35 inches apart from each other.
Answer by: Front Runner
I also have the same Tacoma as Jose (dbl cab short box), and I'm about to purchase a topper (leaning toward a Snug Top Rebel). In the near future I'm planning on putting on the Slimline II over the cab and the topper. I would like to make sure that the cab and the topper racks are level with each other... Is there any way to find out before making the purchases and fitting it all myself you guys can tell me that the fit will be level across my whole truck? If not is there a topper you guys recommend for a level cab and topper rack mount set up? Thank you, Lucas
Question by: Lucas
The best canopy kit to use on a Tacoma hard top would be KRCAT05T. This kit is supplied with taller mounting feet, to ensure both racks are level with each other. Use the link below, to view pictures of the same setup on a Tacoma. http://www.frontrunneroutfitters.com/front-runner-slimline-ii-half-rack-tall-canopy.html
Answer by: Front Runner
I have a double cab Toyota Tacoma with short bed, Bed Length: 60.3in (1,531mm) by Bed Width: 56.7in (1,440mm), and I am getting a Leer 100XR Canopy with the Thule Tracker II System. I don't have the roof top size of the canopy, but I'd assume the rack for roof top sizes of 1165mm/45.9" (W) x 1156mm/45.5" (L) should be the fit. can you confirm this? Also provided the canopy already have the track system, can you confirm which SlimLine II kit or what extra or less components I need to fit the rack to the Thule Tracker II? Thanks, JF
Question by: Jose F
Jose, We can definitely set you up with a rack for your vehicle. All our kits online include tracks but you can order by phone at 818-253-1322 and we can customize the kit without the cost of the tracks. Best Regards, Bryan
Answer by: Front Runner
I have a Thule Tracker II Roof Rack System, will this product fit into the slides without issues?
Question by: Robert Walls
Robert, Our rack systems can mount on any pre-existing Thule or Yakima Tracks already installed on your vehicle. All you would need to do is use the correct size square nuts that are usually already in the tracks. If the square nuts are missing, you can contact the manufacture of your tracks and that can get you the proper hardware. -Bryan
Answer by: Front Runner
Choose Your Country/Region


americas
europe
africa
oceania
asia
middle east