Check new arrivalshere!
Offline mode

Ford F-250/F-350 Super Duty 6' 9" (1999-Current)Slimline II Top-Mount Load Bed Rack Kit

Front Runner
|
SKU: KRFF028T
LIFETIME
WARRANTY*
FREE SHIPPING
TO THE LOWER 48 STATES*
0% APR available for 6, 12, and 18-Month Financing*,
As low as $86/Month for 24-Months*

Double up the loading space on your Ford F-250/F-350 Super Duty (1999-Current) with this 6' 9" (1999-Current) Slimline II Top-Mount Load Bed Rack Kit. The Slimline II’s lightweight, modular construction allows you to customize your setup with over 55 accessories so you can haul all your adventure gear and toys. This particular kit installs on top of the side channel of the load bed of your Super Duty.

Double up the loading space on your Ford F-250/F-350 Super Duty (1999-Current) with this 6' 9" (1999-Current) Slimline II Top-Mount Load Bed Rack Kit. The Slimline II’s lightweight, modular construction allows you to customize your setup with over 55 accessories so you can haul all your adventure gear and toys. This particular kit installs on top of the side channel of the load bed of your Super Duty.

Out of stock
Email me when this is available!
Missed it again? Resubmit a request to be notified.
trust badge
Proven gear and advice
You can trust
guarantee badge
30 DAY MONEY BACK
GUARANTEE
life time badge
BUILT OFF-ROAD
TOUGH

Proven gear and advice

You can trust

30 day money back

Guarantee

Built off-road

Tough

This kit creates a full-size rack that sits above your Ford F-250/F-350 Super Duty 6' 9" truck bed. This Slimline II cargo carrying rack kit contains the Slimline II tray (1575mm x 1762mm), 2 Tracks that install on top of the side channel of the load bed, and 6 Pickup Truck Bed Universal Legs that fit into the Tracks.

All Front Runner Rack Kits contain installation instructions as well as all the components needed to mount the Slimline II Tray to your vehicle.

All Front Runner Racks are backed by a Limited Lifetime Warranty*

Drilling may be required to mount the track to the bed of your truck. See the track and leg installation instructions in the INSTALL tab for further details.

Note: If your Roll Top extrusion has a 6mm (0.24") to 7mm (0.28") slot opening, you may need Track Mount Stud Plate for installation.

{{category_id:3}},{{category_id:84}},{{category_id:120}},{{category_id:158}},{{category_id:177}},{{category_id:179}}