Check new arrivalshere!
Offline mode
Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit
Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit
Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit
Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit
Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit
Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit
Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit
Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit

Volkswagen Amarok (2010-Current) EGR RollTrac Load Bed Load Bar Kit

Front Runner
|
SKU: KRRT010

Clear your bed space and still haul your adventure gear and toys over your Volkswagen Amarok (2010-Current) load bed when fitted with an EGR RollTrac roll cover.

Clear your bed space and still haul your adventure gear and toys over your Volkswagen Amarok (2010-Current) load bed when fitted with an EGR RollTrac roll cover.

Proven gear and advice

You can trust

14 day money back

Guarantee

Built off-road

Tough

A set of Pickup Bed Load Bars used to transport gear over the bed of your Volkswagen Amarok when fitted with an EGR RollTrac roll cover. This low profile solution includes 4 Pickup Roll Top Leg Mounts, 2 1475mm Load Bars that fit into the EGR RollTrac cover tracks, and fitting instructions.

  • The Load Bars are mounted via Pickup Roll Top Load Mounts that bolt directly onto the EGR RollTrac cover tracks.
  • Allows for gear to be mounted above the pickup’s load bed.
  • The load bed retains its load-carrying ability, while the drop-down door functions as usual.
  • Uses the same strong, corrosion-free aluminum slats found in Front Runner Racks.
  • The sliding nut t-slots allow for quick fitting and removal of accessories and equipment on both the top and bottom of the slats.
  • Made from stainless steel and a durable, weather-resistant black powder coated aluminum.
  • Includes all hardware, components, and the installation guide needed to fit Load Bars on a vehicle.

Note: If your Roll Top extrusion has a 6mm (0.24") to 7mm (0.28") slot opening, you may need Track Mount Stud Plate for installation.

Note: The load per Load Bars must not exceed 55lbs or 25kg, and ensure the load is distributed evenly. For larger loads, additional Load Bars may be needed, please contact Customer Service for any enquiries.

{{category_id:74}},{{category_id:77}},{{category_id:120}},{{category_id:159}}