Volkswagen T5/T6 Kombi (2003-Current) w/SCA Pop Top Load Bar Kit

A set of Load Bars used to transport gear on the roof of your Volkswagen T5/T6 (2003-Current) w/SCA Pop Top Roof. This low profile solution includes 4 mounting Feet that fit into OEM SCA Pop Top rails, 2 1345mm Load Bars, 1 10mm Roof Load Bar Wind Deflector and fitting instructions.

• These Load Bars are mounted to the Volkswagen T5/T6 w/SCA Pop Top Roof via a set of supplied Mounted Feet.
• This system installs easily with off-road tough feet that grip onto the existing factory/OEM SCA Pop Top rails. No drilling required.
• Uses the same strong, corrosion free aluminum slats found in Front Runner Slimline II Racks.
• The sliding nut t-slots allow for quick fitting and removal of accessories and equipment on both the top and bottom of the slats.
• The Load Bars and mounting system can be used in the future as components to build a complete Front Runner Roof Rack.
• Made from stainless steel and a durable, weather resistant black powder-coated aluminum.
• Includes all hardware, components and the installation guide needed to fit Load Bars on a vehicle.

Note: The load per Load Bars must not exceed 55lbs or 25kg, and ensure the load is distributed evenly. For larger loads, additional Load Bars may be needed, please contact Customer Service for any enquiries.

* Note: A maximum driving speed of 130km/80mi per hour should be adhered to, when equipped with a Front Runner Roof Rack or Load Bar kit.

KRVK009 - Volkswagen T5/T6 (2003-Current) w/SCA Pop Top Roof Load Bar Kit

Consisting of:
2x FASS024 - Foot Set / 50mm - 60mm
1x LBSK015 - Roof Load Bar Pair 1345mm(W)
2x RRAC940 - Merc Bens Sprinter Slimpro Van Track T-Bolt Kit
1x WDLB001 - Load Bar Wind Deflector / 10mm

Material Used:
Black epoxy powder - coated T6 aluminium

Approximate Installed Weight: 5.61kg (12.37lbs)

The t-slots on the tops and bottoms of the slats accommodate standard 8mm bolts.

To determine the approximate height from your vehicle’s roof to the top of your Load Bar Kit, add the height of the Load Bar (22mm/ 7/8") to the height of the Foot, Grab-On Foot, or Strap-On Foot listed above.

If your Load Bar kit uses Legs, add the height of the Load Bar (22mm/ 7/8") to the height of the Legs listed above to determine the height of the rack from your vehicle's rain gutters.

If your Load Bar kit uses Foot Rails, add the height of the Load Bar (22mm/ 7/8") to the height of the Foot Rails listed above to determine the height of the rack from the crown (highest point) of the vehicles roof.

Shipping Dimensions:
Width: 110mm (4")
Length: 1475mm (58")
Height: 150mm (6")

Shipping Weight:
Weight: 6.2kg (14lbs)